China 20" commercial garage stand fan Manufacturer, Supplier

When a commercial garage or workshop heats up, a powerful floor fan becomes a critical piece of equipment. The 20" commercial garage stand fan is engineered for high-volume air movement in demanding settings, from auto repair bays to fabrication shops. Built on the same durable platform as the 20 inch metal industrial stand fan, this model combines a rugged steel frame with reinforced motor mounts. For cooling large areas, the 20" oscillating industrial pedestal fan configuration sweeps airflow from side to side, preventing hot spots. Operators who need quick adjustments will appreciate the 20 inch 3 speed industrial pedestal fan controls, which deliver low, medium, and high settings. Height flexibility is equally important, and this fan mirrors the convenience of a 20" adjustable height industrial fan with its telescoping stand.

The 20" commercial garage stand fan is designed to move serious air while maintaining a compact footprint. Its three aluminum blades are driven by a thermally protected PSC motor that delivers 6,100 CFM on high. A three-speed rotary switch allows fine-tuned control, while the 90-degree oscillation can be engaged or locked out depending on the task. The fan head tilts through a wide arc, so you can direct airflow upward for stratified heat or downward to cool a workbench. The powder-coated steel housing resists scratches and corrosion, and the round steel base is fitted with rubber isolators to reduce vibration on concrete and epoxy floors.

This fan performs especially well in automotive bays, woodshops, and warehouse loading areas. On low speed, it provides gentle circulation for occupied spaces; on high, it pushes heat and fumes toward open doors or exhaust fans. The adjustable height and tilt make it equally useful at floor level for drying a recently mopped concrete slab or at bench height for cooling an engine block after a test run. Because the stand is steel with a wide base, the fan stays put even when the oscillation is active on high speed.

• Motor: 1/4 HP, 120V/60Hz, thermally protected PSC, permanently lubricated
• Blade diameter: 20 inches, 3-blade aluminum assembly, balanced for smooth operation
• Airflow: 6,100 CFM on high, 4,800 CFM on medium, 3,200 CFM on low
• Speed control: Three-speed rotary switch located on the rear motor housing
• Oscillation: 90-degree sweep, toggle-controlled, can be locked out
• Height adjustment: 42 to 55 inches, telescoping steel column with locking knob
• Head tilt: 30 degrees up or down
• Power cord: 10 ft, grounded 3-prong, SJT jacket
• Certifications: ETL/cETL listed, meets OSHA guard requirements
• Weight: 44 lb
• Base diameter: 22 inches, round steel plate with rubber isolators
• Finish: Powder-coated steel housing and grille

The fan’s motor is rated for continuous duty, so it can run through an entire shift without overheating. A built-in thermal overload switch automatically shuts the motor off if internal temperatures exceed safe limits, then resets after cooling. The grounded cord and ETL listing make it suitable for commercial settings, and the control switch is sealed against dust and light moisture. Each unit is assembled with balanced aluminum blades and a dynamically tested motor to reduce wobble and extend service life. The rear-mounted controls are easy to reach, and the oscillation mechanism uses a durable gear drive rather than a plastic cam. For shops that run fans around the clock, the sealed bearings and thermally protected motor provide reliable performance without frequent lubrication. The grille is removable for routine cleaning, and the base can be bolted to the floor through pre-drilled holes if a permanent installation is preferred.